Sharp 16 Series Manual page 5

Read the following instructions before operating the machine.
 Only authorized personnel should work on this machine. Untrained personnel
present a hazard to themselves and the machine, and improper operation will
void the warranty.
 Check for damaged parts and tools before operating the machine. Any part or
tool that is damaged should be properly repaired or replaced by authorized
personnel. Do not operate the machine if any component does not appear to be
functioning correctly.
 Use appropriate eye and ear protection while operating the machine. ANSI-
approved impact safety goggles and OSHA-approved ear protection are
recommended to reduce the risks of sight damage and hearing loss.
 The Emergency Stop button is the large, circular red switch located on the
Control Panel. Pressing the Emergency Stop button will instantly stop all motion
of the machine.
 The electrical panel should be closed and the key and latches on the electrical
cabinet should be secured at all times except during installation and service. At
those times, only qualified electricians should have access to the panel. When the
main circuit breaker is on, there is high voltage throughout the electrical panel.
Once the machine is installed, the electrical cabinet must be locked and the key
available only to qualified service personnel.
 DO NOT modify or alter this equipment in any way. If modifications are
necessary, all such requests must be handled by SHARP INDUSTRIES, INC.
Any unauthorized modification or alteration of any sharp MACHINES could
lead to personal injury and/or mechanical damage and will void your warranty
4