Wps - D-Link DSL-2750U User Manual

DSL-2750U Wireless N300 ASDL2+ Router with Ethernet WAN Support
User Manual

WPS

On the Wi-Fi / WPS page, you can enable the function for configuration of the WLAN and select a
method for connection to the WLAN.
The WPS function helps to configure the protected wireless network automatically. Devices
connecting to the wireless network via the WPS function must support the WPS function.
!
The WPS function allows adding devices only to the basic wireless network of the router.
Before using the function you need to configure one of the following authentication types:
!
Open with no encryption, WPA2-PSK or WPA-PSK/WPA2-PSK mixed with the AES
encryption method. When other security settings are specified, controls of the WPS page
are not available.
You can activate the WPS function via the web-based interface or the hardware WPS/WLAN
button on the cover of the device.
To activate the WPS function via the hardware button, move the Enable Wi-Fi when WPS
function is activated with hardware button switch to the right. Then, with the device turned
on, press the WPS/WLAN button and release it. The WPS LED should start blinking. In addition,
upon pressing the button, the wireless interface of the device is enabled if it was disabled before.
If you want to disable activating the WPS function via the hardware button, move the Enable
Wi-Fi when WPS function is activated with hardware button switch to the left and make
sure that the WPS function is not activated via the web-based interface.
To activate the WPS function via the web-based interface, click the ENABLE WPS button.
Figure 89. The page for configuring the WPS function.
Page 110 of 173
Configuring via Web-based Interface