Table of Contents
Advertisement
2.4.3
Upload of Address Translation Table
Before uploading the data, place the card in the "STOP" status (see "2.3.1 Status Control").
1.
Click 3.3 Upload of DN2IP data (PC –> VoIP Gateway) in the main menu.
2.
Click Browse and choose a file to upload.
At any time during the session, you can:
•
Click MENU to return to the main menu (see "2.1 Main Menu for the Administrator").
•
Click LOGOUT to log out from the IP-GW4 Maintenance Utility (see "2.5.2 Log Out").
3.
Click UPLOAD(PC–>VoIP Gateway).
The upload operation starts.
Notes
•
•
If the upload operation is executed while the card is in the "RUN" status, you will
see an error screen. Click Change RUN/STOP status Screen and place the
card in the "STOP" status (see "2.3.1 Status Control"), and then upload the data
again.
If the operation is not successful for other reasons, you will see another error
screen. Click OK to return to the previous screen, and then upload the data
again.
2.4 Data Management
Programming Guide
47
Advertisement
Table of Contents
