Table of Contents
Advertisement
18
en | Installing Roof Parapet and Pipe Mounts
The following figure depicts the parts for the roof parapet and pipe mounts.
Trim Skirt
TRIM SKIRT
(OPTIONAL)
PIPE MOUNT ASSEMBLY
Pipe Mount Assembly
INTERFACE MODULE
PENDANT HOUSING
COMMS MODULE
CPU MODULE
CAMERA MODULE
DOME BUBBLE
Fig. 2.1 Roof Parapet and Pipe Mount Parts
2.1.2
Description
Chapter 2 details how to install the AutoDome to a Roof Parapet and a Pipe mount. Any differ-
ences to the installation between these two mounting systems are noted. See Chapter 1 if you
are installing a Pendant Arm to a Wall, Corner, or Mast (or pole) or see Chapter 3 if you are
mounting an In-ceiling AutoDome.
The VG4-A-9230 Series are stationary mounts intended for rooftop parapet vertical walls. They
are made of light weight aluminum with a corrosion-resistant finish and are used for all Bosch
AutoDome systems up to a rated load of 29 kg (64 lb). These mounts can be fitted to the
inside or outside of parapet walls and can swivel for ease of positioning and for servicing the
AutoDome.
F01U010921 | 1.0 | 2006.10
Power Supply
POWER SUPPLY
GASKET
FLANGE
CAP
Interface Module
Pendant Housing
COMMS Module
CPU Module
Camera Module
Dome Bubble
Installation Manual
AutoDome Modular Camera System
Power Supply Cover
POWER SUPPLY COVER
Roof Parapet Mount
ROOF PARAPET MOUNT
ENVIROMENTAL SHIELD
Environmental Shield
Thermal Module
THERMAL MODULE
Bosch Security Systems, Inc.
Advertisement
Table of Contents
