Table of Contents
Advertisement
AutoDome Modular Camera System
2.3.1
Attach Cover Door
1.
Compress the bottom hinge pins by pushing the pin lever down and then rotate it behind
the Hinge Pin Stop. The power box Cover Door provides a Hinge Pin Stop to hold the bot-
tom hinge open while attaching the door.
Fig. 2.3 Align Cover Door Hinge to Power Box
2.
Open the top hinge by pushing its pin lever outward and holding it open.
NOTICE! Both Hinge Pins must be fully compressed to open (unlock) the female hinges of the
i
Cover Door before proceeding to the next step.
3.
While holding the top hinge pin open, position the Cover Door to the Power Supply Box
and align its hinges.
4.
When the hinges are aligned, release the top hinge pin to engage its mating hinge on the
power box. Then release the bottom hinge pin from the Hinge Pin Stop to complete
attaching the Cover Door to the Power Supply Box.
NOTICE! After all wiring is complete, close the cover door and tighten the two (2) captive
i
screws on the cover door to 10-12 N-m (90-105 in.-lbs) to ensure the Power Supply Box is
watertight.
Bosch Security Systems, Inc.
Power Supply Box
POWER SUPPLY BOX
LINE NC NEUT
GND TXD RXD
C+ C-
GND TXD RXD
C+ C-
Installation Manual
Installing Roof Parapet and Pipe Mounts | en
Cover Door
COVER DOOR
o
90
Align
ALIGN
Top
Hold Hinge Pin Open
HOLD HINGE PIN OPEN
TOP
Hinge
HINGE
Open
OPEN
Position
POSITION
Align
ALIGN
Hinge Pin Stop
HINGE PIN STOP
Bottom
BOTTOM
Hinge
HINGE
21
F01U010921 | 1.0 | 2006.10
Advertisement
Table of Contents
