Table of Contents
Advertisement
AutoDome Modular Camera System
1.7
Assemble Pendant in Packing Box
The AutoDome Pendant must be assembled before attaching it to the roof or pipe mount. The
Pendant includes a Housing, Camera Module, and Bubble.
NOTICE! The Pendant Housing box is designed to hold the Pendant Housing in-place during
i
the assembly of the Pendant.
1.
Open the top of the box containing the Pendant Housing, and remove the two cardboard
inserts.
2.
Remove the plastic bag from the Pendant Housing, and place the housing back into the
packing box.
3.
Remove the Camera Module from its packing box and remove the protective plastic bag.
4.
Align the yellow locking tab on the base of the Camera Module to the yellow label on the
CPU board and gently seat the camera into its connector.
Fig. 1.10 Align and Attach Camera Module
5.
Rotate the yellow locking tab of the Camera Module clockwise (approximately 60
degrees) until the Camera Module locks in place.
NOTICE! The Camera Module must be able to rotate freely when installed in the housing.
i
Bosch Security Systems, Inc.
Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en 13
Installation Manual
F01U010921 | 1.0 | 2006.10
Advertisement
Table of Contents
