Table of Contents
Advertisement
12-3.Check Items before test run
No.
1
Has the electrical work (power supply and communication wiring work) been completed?
1.When the Energy Monitoring Relay Interface or Digital Input / Output Relay Interface is connected, check that the
polarity (A / B) of the wiring is correct.
2.Check that the terminal resistance has been set.
3.When a custom device is connected, check that the TCC-LINK adaptor has been connected.
2
Has the addresses of the air conditioner (Indoor units (DN=03, 12, 13, 14)) and outdoor unit (outdoor unit control board
switch 13 / 14) been set?
1.Check that the address of the general device interface has been set.
3
Has the setting file been created and uploaded?
4
Have the controller switch and DN been set?
5
Has the controller IP address been checked?
6
Have the network and the browser proxy of the PC to be connected been set?
7
Are all the devices turned on?
When the power distribution function is used:
8
Is the Data Download Software installed?
9
Is the Monthly Report Creation Software installed?
10
Is the network setting completed for the PC where the Monthly Report Creation Software is installed?
Check item
Key point
Key point
31
Advertisement
Table of Contents
