Advertisement
Verify that you received the following items:
Focus/Iris controller is designed to control operation of Panasonic DVX-100B and HVX-200 cameras.
Variable stepless Focus control
Conneting with support (square, rectangular, round tube/pipe/bar)
Clamp range: square or rectangular tube of flat surfaces: 5mm-30mm height
Clamp range: round tube/pipe/bar: 35mm diameter
Move the "Focus custom/std" to STD position-left.
Rotate focus wheel clockwise (or counter-clockwise, dependent on the focus direction switch) to change focus on the camera from close to far. Focus will change within full range available on the camera.
Note: minimal focus value, may be limited by zoom lenses.
"0" value can be obtained only when camera zoom is not maximum wide.
Move the "Focus custom/std" to CUSTOM position-right.
Setup focus close and far limits:
Rotate focus wheel clockwise (or counter-clockwise, dependent on the focus direction switch) to change focus on the camera from close to far. Focus will change within setup limits.
Note: In mode with focus limits you may not always be able (depends on camera type) to focus through whole available focusing range on the camera. If focusing far/close objects are beyond those limits, use focus mode without limits.
To change the Focus direction, move Focus direction switch, found on the top left side of the controller body, to opposite position.
Rotate the manual Iris knob clockwise (or counterclockwise, dependent on the iris direction switch) to change iris from open to close.
To change the Iris direction, move Iris direction switch, found on the top right side of the controller body, to opposite position.
To change focus mode from standard (std) to custom move custom/std switch to left.
To change focus mode from custom to std move custom/std switch to right.
To change iris mode from manual to auto move iris A/M switch to left.
To change iris mode from auto to manual move iris A/M switch to right.
We put a lot of attention on making the controller to be as much water resistant as possible, while maintaining its reasonable price.
However we cannot guarantee 100% water resistance under all circumstances and you should avoid using the controller under heavy environment conditions like rain and over 95% humidity level.
Avoid temperatures exceeding +70°C – especially do not leave the controller exposed for direct contact with heavy sun shines, e.g. in the car parked in sunny place.
Operation temperature range -10°C - +60°C
Storage temperature range -30°C - +80°C
Humidity rel. (non condensing) max. 95%
The information contained in this document is subject of change without notice.
Manfrotto makes no warranty and shall not be liable for any errors on information contained in this document.
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the 521PFi that isn't answered in the manual? Leave your question here.