Table of Contents
Advertisement
Automationstechnik
!
1070 080 056-101 (99.09) GB
Safety instructions and reader's information
-
Fault reset with spot repetition
If the start signal is present when a fault is reset with reweld (spot repetition), the
timer will immediately start executing the program! This may result in dangerous
machine movements! Therefore, before resetting a fault with reweld it must be en-
sured that nobody is in the dangerous area of the welding machine!
-
Simulate start
In remote-controlled systems, program execution may begin which may result in
dangerous machine movements. Therefore, before remote starting, it must be en-
sured that nobody is in the dangerous area of the welding machine!
CAUTION!
Damage to property through excessive welding current!
The maximum welding current of the welding hardware used must not be exceeded. No
liability is accepted in the event of non-compliance.
XV
Advertisement
Table of Contents
