Table of Contents
Advertisement
Installing the Charging
Station
CAUTION
• Do not allow children or pets to hang onto the
charging station. They could be injured or cause
damage to the appliance.
• Take care not to drop the product parts while
unpacking them to avoid appliance damage or
personal injury.
NOTE
• The cost of a service call to install or reinstall the
charging station is not covered under the
warranty.
Installation
Follow the steps below to install the charging
station on a hard and level floor.
CAUTION
• Do not install on carpeted floors or rugs. The
product may fall, causing injury or damage.
• If the base plate and the product are not
properly assembled, the product may fall over,
causing product damage or injury.
1
Before installing the product, attach the
gaskets
to the four grooves on the rear of
a
the base plate
.
b
• Peel off the paper from the gasket, remove
foreign substances from the groove, and
then attach the sticky side of the gasket to
the base plate.
• Attaching the gaskets on the base plate can
prevent the base plate from slipping or
scratching the floor when installing the
product.
2
Place the base plate on a flat, hard surface
with the long side facing forward. Place the
product onto the base plate.
• Install the base plate with at least 2" (5cm)
of clearance in the rear. If you plan to store
the mop nozzle on the station, allow more
than 2" (5 cm).
• Keep an 8" (20cm) radius in the front clear
of obstacles in order to open the doors of
the station.
5 cm
3
Place the station on the base plate and press
down firmly on all sides to secure it on the
base.
• When properly assembled, the base plate
and station should sit flat on the floor with
no wobbling or bulges in the base plate.
4
Using the anti-tip kit, fix the product firmly to
the wall.
INSTALLATION
11
20 cm
Advertisement
Table of Contents
