Remove The Battery Pack; Remove The Solid-State Drive (Ssd) - Lenovo ThinkBook 14s Gen 2 Hardware Maintenance Manual

Lower case

Remove the battery pack

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 35
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Release the speaker cable from the cable guide and remove five screws. Then, remove the battery
pack.
Figure 7. Remove five screws and remove the battery pack
Screw specifications
M2 x L3
Go to
https://support.lenovo.com/partslookup
part:
Battery pack

Remove the solid-state drive (SSD)

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 35
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Remove one screw.
36
Hardware Maintenance Manual
Number of screws
5
to look up the Lenovo part number of the following replacement