Remove The I/O Bracket (Left) - Lenovo ThinkBook 14s Gen 2 Hardware Maintenance Manual

Step 5. Remove two screws and then remove the I/O bracket (right).
Figure 17. Remove two screws and remove the I/O bracket (right)
Screw specifications
M2 x L4
Go to https://support.lenovo.com/partslookup
part:
I/O bracket (right)

Remove the I/O bracket (left)

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 35
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Peel off the tape.
Figure 18. Peel off the tape
Step 3. Remove three screws and then open the hinge.
Number of screws
2
to look up the Lenovo part number of the following replacement
.
Chapter 4 Removing a FRU or CRU
41