Table of Contents
Advertisement
7 Installation
Prior to installation, the following documents should be to hand:
• Data sheet of the product (contains the permissible technical data,
main dimensions and circuit diagrams of standard versions)
7.1 Unpacking
NOTICE! Danger due to electrostatic discharge!
When unpacking the sensor, there is a danger of damage to the electronic
components of the sensor due to electrostatic discharge.
▶ When unpacking, protect the sensor against electrostatic discharge;
information on the protection of the sensor against electrostatic discharge (ESD)
can be found in the respective data sheet (Table 1 "Required and supplementary
documentation" on page 5).
▶ Remove the packaging from the speed sensor.
▶ Check the sensor for transport damage and completeness, see chapter 4
"Scope of delivery" on page 15.
▶ Dispose of the packaging in accordance with the regulations in your country.
7.2 Installation conditions
The installation position and position of the speed sensor essentially determine the
procedures for installation and commissioning.
▶ Do not install the sensor close to parts that generate considerable heat
(e. g. exhaust systems).
▶ Lines are to be routed with sufficient distance from hot or moving vehicle parts.
▶ A sufficient distance to radio systems must be maintained.
▶ Before electric welding and painting operations, the sensor must be diskonnected
from the power supply and the sensor connector must be removed.
▶ Cables/wires must be sealed individually to prevent water from entering
the sensor.
▶ Use wiring harness connectors to protect the sensor against ingress of water.
7.3 Installing the speed sensor
7.3.1 Preparation
1. Use the material number on the sticker of the packaging unit or directly on the
sensor or electric cable to check whether the correct speed sensor is available,
see chapter 4 "Scope of delivery" on page 15.
2. Compare the material number with the details in the order confirmation.
If the material number of the speed sensor does not match the one in
the order confirmation, contact your local contact person for clarification.
You can find their contact information at
https://addresses.boschrexroth.com
Installation | BODAS speed sensors
RE 95290-01-B/2021-09-13, Bosch Rexroth AG
27/36
Advertisement
Table of Contents
