LG LFXS28566 Series Technical Manual page 178

Product Category
Washer Overflow or Leak
Washer Cool Down
Washer Current Error
Washer Child Lock
Washer Door Error
SideKick washer Door Error
Washer Dry Heater Error
Washer top load door lock
Washer clutch error
Washer Stacking Switch Error
SideKick washer Incorrect operation
Washer
Washer Fill Error
Washer Freezing Failure
Washer Environment caused
Washer Inlet Error
Failure Code Explanation
The AE error indicates a problem with a leakage inside the
appliance. Note: the appliance has a safety mechanism
installed to prevent flooding the floor. If a water leakage
AE occurs
The Cd error is a notification that the program is finished.
Cd Explain that when Cd is displayed
The CE error indicates a problem with the Direct Drive
motor control. Note: the appliance has several detection
mechanisms to control the Direct Drive motor. The current
CE control is one of them
The CL error is a notification that the appliance is locked
for program changes by the customer. Note: when CL is
CL displayed
The dE error indicates a problem with the door lock system
dE; dE1; dE2; dE4 not closing the power circuit loop.
door or drawer issue
dE1; dE2; dE3
The dHE error indicates a problem with the overheating
protection system. This protection will signal for high
temperature and shut down the appliance. (Specific for the
Combo)
dHE
dL door lock switch; check balance of lid
E6 top loader clutch error
The E7 error indicates a problem with the stacking switch
(accessory separation detection). The appliance is stopped
as it cannot continue in the program. Note: the Mini-
E7 Washer is not intended to run without an Main WM.
Operated without a full size washer or stacking switch is
E7 not working properly
EEPROM Error
EE
The FE error indicates a problem with water overfilling. In
normal operation the drain pump is activated to prevent
FE leakages.
The FF error indicates a temperature problem in the tub.
The tub temperature dropped below 1 degree Celsius due
FF to a cold environment
FF component if frozen due to cold environment
The IE error indicates a problem with the water supply.
Note: the appliance has a water inlet detection and
IE correction system
Remarks
an open door after program start: a not completely closed
door: a faulty door lock: a faulty Main PCB
wrong or failing water supply
a missing separation key: a faulty separation switch: a faulty
harness: a faulty Main PCB
EEPROM is out of order
a customer filling the appliance with additional water
drain hose/supply hose/drain pump frozen
frozen water tap: a kinked inlet hose: a clogged inlet (hose)
filter after a longer period of use: a clogged dispenser.
Faulty water inlet assemblies: a faulty Main PCB