How To Reach The Rear Side Of The Ied; Side-By-Side 19" Rack Mounting; Overview - Hitachi 670 Series Installation Manual

1MRK514026-UUS Rev. P
PosNo
4
5
6
5.3.3.3

How to reach the rear side of the IED

The IED can be equipped with a rear protection cover recommended to be used with this type of
mounting. See figure 6.
To reach the rear side of the IED, a free space of 3.2 inches is required on the unhinged side.
ANSI06000135 V2 EN-US
Figure 6:
PosNo
1
2
3
5.3.4

Side-by-side 19" rack mounting

5.3.4.1

Overview

IED case size 1/2 x 19" or 3/4 x 19" and RHGS cases can be mounted side-by-side up to a maximum
size of 19". For side-by-side rack mounting, the side-by-side mounting kit together with the 19" rack panel
mounting kit must be used. The mounting kit has to be ordered separately.
670 series
Installation manual
Description
Mounting bar
Screw
Side plate
How to reach the connectors on the rear side of the IED.
Description
Screw
Screw
Rear protection cover
Use only the screws included in the mounting kit when mounting the plates and the angles on
the IED. Screws with wrong dimension may damage the PCBs inside the IED.
© 2017 - 2023 Hitachi Energy. All rights reserved
Quantity Type
2 -
6 M5x8
2 -
Type
M4x10
M5x8
(Ordered separately)
Section 5
Mounting
M11941-2 v5
IP10323-1 v1
M11974-3 v3
25