Toro Groundsmaster 360 Operator's Manual page 15

Parking Brake
To engage the parking brake, push down on the brake pedal
and press the top forward to latch
parking brake, press the brake pedal until the parking brake
latch retracts without contacting the locking mechanism.
Tilt Steering Pedal
To tilt the steering wheel towards you, press the foot pedal
down, and pull the steering tower toward you to the most
comfortable position and then release the pedal
move the steering wheel away from you, press the foot pedal
and release it when the steering wheel reaches the desired
operating position.
Ignition Switch
The ignition switch has three positions: Off, On/Preheat,
and Start (Figure 6).
1. Power take off (PTO)
Switch
2. Oil pressure warning light
3. Charge indicator light
4. Hour meter
5. Differential lock switch
(optional-2 wheel drive
only)
6. Steering selector switch (4
wheel drive only)
7. Throttle lever
Diagnostic Light
It will illuminate should a system fault be recognized
6).
(Figure 5). To release the
(Figure
Figure 6
8. Diagnostic light (4 wheel
drive only)
9. Ignition switch
10. Power point
11. Optional switch location
12. Deck lift switch
13. Glow plug light
14. Engine coolant
temperature warning
light
Throttle Lever
The throttle lever
Moving the throttle lever forward toward the Fast position
increases the engine speed. Moving it rearward toward the
Slow position decreases the engine speed. The throttle
controls the speed of the PTO and, in conjunction with the
traction pedal, controls ground speed of the machine. Always
run the machine with the throttle in the Fast position when
operating attachments.
Power Take Off (PTO) Switch
5). To
The power take off (PTO) switch starts and stops the
attachment (Figure
Steering Selector Switch
Press the steering selector switch to the rear to engage 4 wheel
steering and forward to return to 2 wheel steering
Hour Meter
The hour meter
engine has operated. It operates when the key switch is in
the Run position. Use these times for scheduling regular
maintenance.
Glow Plug Light (Orange Light)
The glow plug indicator light
ignition switch is turned to the On position. It remains lit
for 6 seconds. When the light turns off, the engine is ready
to be started.
Engine Coolant Temperature Warning
Light
This light glows and the cutting blades stop if the engine
coolant temperature is high
stopped and the coolant temperature rises another -7° C (20°
F), the engine will stop.
Important: If the attachment shuts down and the
temperature warning light is on, push PTO knob down,
drive to a safe flat area, move the throttle lever to the
Slow position, allow the traction pedal to move to the
neutral position, and engage the parking brake. Allow
the engine to idle for several minutes while it cools to a
safe level. Stop the engine and check the cooling system;
refer to Checking the Cooling System.
Charge Indicator
Illuminates when the charging system circuit malfunctions
(Figure 6).
Oil Pressure Warning Light
(Figure
The oil pressure warning light
pressure in engine drops below a safe level. If low oil pressure
15
(Figure 6) controls the speed of the engine.
6).
(Figure 6) records the number of hours the
(Figure 6) turns on when the
(Figure 6). If the machine is not
(Figure 6) glows when the oil
(Figure 6).