Optional Mower Deck Mounting Hardware; Checking The Tire Pressure - Toro Groundsmaster 360 Operator's Manual

Figure 3
1. Wire harness electrical connector
3. Position the PTO drive shaft under the front of the
machine. Make sure that the drive shaft slip shaft yoke
(Figure 4) is toward the transmission PTO shaft.
G018340
5
Figure 4
1. Transmission drive shaft
2. Capscrew
3. PTO shaft
4. Align the spline and roll pin hole of drive shaft yoke
with the transmission shaft.
5. Slide PTO drive shaft end yoke onto the transmission
PTO shaft.
6. Secure the end yoke of the PTO drive shaft as follows:
A. Install the roll pin in the end yoke and shaft.
B. Install the capscrews thru the drives shaft end
yoke.
C. Install and tighten the lock nuts to secure the end
yoke to the PTO shaft. Torque the lock nuts to 20
to 25 N-m (175 to 225 in-lb).
Note: Retain the remaining capscrews, locknuts
and roll pin to secure the other end of the drive
shaft to the attachment gear box shaft.
7. Lubricate the PTO drive shaft grease fittings.
G018339
1
1
2
3
4
4. Locknut
5. Roll pin
8. After the other end of the drive shaft is connected
to the attachment gear box shaft, connect the wire
harness electrical connector to the PTO solenoid valve
coil connector (Figure
2
Optional Mower Deck
Mounting Hardware
Parts needed for this procedure:
2 Retainer pin
2 Grease fitting
2 Washer head screw, 5/16 x 7/8 inch
Procedure
Note: These components and procedure are only required if
a mower deck, that requires retainer pins, is mounted to the
traction unit. Refer to the Mower Deck Operator's Manual
for the installation instructions
Note: If a mower deck is not to be installed on the traction
unit, remove or tie up the (4) deck lift chains from the lift
suspension.
3

Checking the Tire Pressure

No Parts Required
Procedure
The tires are over inflated for shipping. Therefore, release
some of the air to reduce the pressure. The correct air
pressure for non-cab models is 103 kPa (15 psi) in the front
tires and 172 kPa (25 psi) in the rear tires. If a cab is installed
on the machine, the front and rear tires should be inflated to
172 kPa (25 psi).
13
3).