Using The Optional Mower-Deck-Mounting Hardware; Checking The Tire Pressure - Toro 31236 Operator's Manual

Figure 3
1. Wire-harness connector
3. Position the PTO driveshaft under the front of the
machine. Ensure that the slip-shaft yoke of the
driveshaft is positioned toward the transmission
driveshaft (Figure 4).
G018340
5
Figure 4
1. Transmission driveshaft
2. Bolt
3. PTO driveshaft
4. Align the spline and roll-pin hole of the driveshaft yoke
with the transmission driveshaft.
5. Slide the PTO driveshaft end yoke onto the
transmission driveshaft.
6. Secure the end yoke of the PTO driveshaft as follows:
A. Install the roll pin in the end yoke and shaft.
B. Install the bolts through the driveshaft end yoke.
C. Install and tighten the locknuts to secure the end
yoke to the PTO driveshaft.
Note: Retain the remaining bolts, locknuts, and
roll pin to secure the other end of the driveshaft
to the attachment gearbox shaft.
D. Torque the locknuts to 20 to 25 N-m (175 to 225
in-lb).
7. Lubricate the grease fittings on the PTO driveshaft.
G018339
1
1
2
3
4
4. Locknut
5. Roll pin
8. After you connect the other end of the driveshaft to
the attachment gearbox shaft, connect the wire-harness
connector to the PTO solenoid-valve-coil connector
(Figure 3).
2
Using the Optional
Mower-Deck-Mounting
Hardware
Parts needed for this procedure:
2 Retainer pin
2 Grease fitting
2 Washer head screw (5/16 x 7/8 inch)
Procedure
Note: These components and procedure are required only
if a mower deck that requires retainer pins is mounted to the
traction unit. Refer to the mower deck Operator's Manual for
the installation instructions.
Note: If you are not installing a mower deck on the traction
unit, remove or tie up the 4 deck-lift chains from the lift
suspension.
3

Checking the Tire Pressure

No Parts Required
Procedure
The tires are overinflated for shipping. Therefore, release
some of the air to reduce the pressure. All tires should be
inflated to 172 kPa (25 psi).
11