Operating A Mower Deck Or Attachment - Toro 31236 Operator's Manual

5. Connect the Diagnostic ACE connector to the
appropriate harness connector. If the machine comes
with a front attachment, it will have 2 controllers.
Note: Ensure that the correct overlay decal is
positioned on the Diagnostic ACE.
6. Turn the key switch to the O
start the engine.
Note: The red text on the overlay decal refers to input
switches and the green text refers to outputs.
7. The "inputs displayed" LED, on the lower right
column of the Diagnostic ACE, should be illuminated.
If the "outputs displayed" LED is illuminated, press
the toggle button on the Diagnostic ACE to change it
to "inputs displayed."
Note: You may need to toggle between "inputs
displayed" and "outputs displayed" several times to do
the following step. To toggle back and forth, press the
toggle button once. Do this as often as necessary; do
not hold the button.
8. Sit on the seat and attempt to operate the desired
function of the machine. The appropriate output
LEDs should illuminate to indicate that the ECM is
turning on that function.
Note: If the correct output LEDs do not illuminate, verify
that the required input switches are in the necessary positions
to allow that function to occur. Verify the correct switch
function.
If the output LEDs are on as specified but the machine does
not function properly, this indicates a non-electrical problem;
repair as needed.
Note: If each output switch is in the correct position and
functioning correctly but the output LEDs are not correctly
illuminated, this indicates an ECM problem. If this occurs,
contact your Toro Distributor for assistance.
Important: Do not leave the Diagnostic ACE display
connected to the machine. It is not designed to
withstand the environment of the everyday use of the
machine. After using the Diagnostic ACE, disconnect it
from the machine and connect the loop-back connector
to the wire-harness connector. The machine cannot
operate without the loopback connector installed on the
wire harness. Store the Diagnostic ACE in dry, secure
location in the shop, not on the machine.
position, but do not
N
Operating a Mower Deck or
Attachment
Optional
Raising and Lowering the
Mower/Attachment
The deck-lift switch raises and lowers the mower
deck/attachment (Figure
for you to use this switch.
1. Deck-lift switch
•
To lower the mower deck/attachment, push the switch
forward.
•
To raise the mover deck/attachment, push the switch
rearward.
Important: Do not continue to hold the switch back
after the mower/attachment is fully raised. Doing so
will damage the hydraulic system.
Note: To lock the mower deck/attachment in the raised
position, raise the deck past the 15 cm (6 inch) position,
remove the height-of-cut stop pin (refer to
Height-of-Cut (page 26)), and insert the pin into the 15 cm (6
inch) height-of-cut position
Engaging the Power Takeoff (PTO)
The power-takeoff (PTO) switch starts and stops the mower
blades and some powered attachments.
1. If the engine is cold, allow the engine to warm up 5 to
10 minutes before engaging the PTO.
2. While seated in the seat, ensure that the traction pedal
is in the
NEUTRAL
full throttle.
3. Pull up the PTO switch to engage it
25
23). The engine must be running
Figure 23
Adjusting the
(Figure 25).
position and that the engine is at
(Figure 24).