Installing The System Software (Sst -> Usb) - Canon iR C2880 Series Service Manual

Chapter 18
18.2.2 Installing the System Software (SST -> USB)
iR C3380i / iR C3380 / iR C2880i / iR C2880 / iR C3580 / iR C3580i / iR C3080i
Here, you will be copying the system software from the SST to a USB device.
[Preparatory Work]
Requirements
- PC installed with SST version 3.22 or later
- USB device (*)
*: USB Requirements
Interface
Capacity
Format
You will not be able to use a security-protected USB device. Be sure to remove the protection before use.
[Copying the System Software]
1) Start up the PC.
2) Connect the USB device to the USB port of the PC.
3) Start up the SST.
4) Click the USB icon on the Target Selection screen.
5) Select the drive to which the USB device has been connected.
18-8
Service Support Tool DLM0 (Ver.3.22E)
Registerd Firms CONTROL
C l i c k a b u t t o n t o exe c u t e .
Registered fir mware
CONNECT
XXenvXXXX
iRC3380
R e g i s t e r F i r m wa r e
RCON
XXxxvXXXX
iRCXXXX D e l e t e F i r m wa r e
HDFormat
XXxxvXXXX
D e l e t e B a ck u p D a t a
KEY
XXxcvXXXX
S y s t e m M a n a g e m e n t
O K
Model Configuration Info : Update
OK
CANCEL
EXIT
F-18-7
USB 1.1 or higher (USB 2.0 or recommended)
1 GB or more recommended
(A set of system software is in excess of 512 MB.)
FAT (FAT16), FAT32 (It must not be NTFS or HFS.)
single partition (There must not be multiple partitions.)
Service Support Tool DLM0 (Ver.3.22E)
Target Selection CONTROL
S e l e c t t h e t a r g e t . C l i c k a b u t t o n t o exe c u t e .
MFP
E x p o r t F i r m wa r e
MFP
R e g i s t e r F i r m wa r e
USB
D e l e t e F i r m wa r e
D e l e t e B a ck u p D a t a
S y s t e m M a n a g e m e n t
USB
c:
START
Select the destinate drive.
CANCEL
EXIT
F-18-8
Found Firm
F i r m wa r e r e g i s t ra t i o n c o m p l e t e d .
> > > B a t c h R e g i s t ra t i o n R e s u l t s
iRC3380
BOOT
XXxxvXXXX Regist
>>>
SYSTEM
USenvXXXX >>> Regist
TTS
XXenvXXXX Regist
>>>
RUI
XXenvXXXX >>> Regist
LANGUAGE
XXenvXXXX >>> Regist
BROWSER
XXxxvXXXX Regist
>>>
DCON
XXxxvXXXX >>> Regist
MEAPCONT
XXxxvXXXX Regist
>>>
Export Firm Selection
S e l e c t t h e d e s t i n a t e d r i ve .
Series
Version
Firmware registration status
0014-4491