Sharp Actius PC-GP20 Operation Manual page 81

Entering and Exiting the Setup Utility
1. Turn on the computer.
2. When <F2> to enter System Configuration Utility appears, press F2. The Setup
Utility opens.
3. Set the settings to the appropriate ones. Refer to the next section.
4. Select Exit menu; then press Enter.
5. Select one of the exit methods, and press Enter.
6. Confirm the message and press Enter again. The system restarts.
Changing the setting of the Setup Utility
To change the settings:
Use → or ← key to select the menu; then press Enter.
1.
Use ↑or ↓ key to select the item.
2.
If the item has
Press Enter to enable or disable the item.
enabled.
If the item has no mark (except Date and Time of Main menu and Set Password
6
of Security menu):
1. Press Enter to open the sub menu.
2. Use Tab key to highlight the value; then use ↑ or ↓ key to select the
value. The value with • is being selected.
3. Use Tab key to highlight OK; then press Enter.
To set Date and Time:
1. Press Enter.
2. Use arrow keys to highlight the value; then use minus key or space bar to
change the value.
3. Use arrow keys to highlight OK; then press Enter.
To set Set Password: see Security Menu in this chapter.
3. Close the Setup Utility according to the steps above.
When the Setup Utility is opened, power management does not work. Do
not close the display cover.
6-2
or :
Mark means disabled.
mark means the item is