Table of Contents
Advertisement
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
1
Installing the Grinder Control
Lever
Parts needed for this procedure:
1
Grinder control lever
1
Jam nut
Procedure
1. Thread the jam nut onto the grinder control lever
(Figure 4).
1. Grinder control lever
2. Jam nut
2. Thread the grinder control lever into the recepticle on
the control panel (Figure 4).
Description
Grinder control lever
Jam nut
No parts required
No parts required
Figure 4
3. 4-pin connector
Qty.
1
Install the grinder control lever.
1
–
Check the fluid levels.
–
Charge the battery.
3. With the trigger oriented forward, tighten the jam
nut against the receptacle to secure the lever in place
(Figure 4).
4. Connect the wire on the lever to the 4-pin connector
under the control panel (Figure 4).
2
Checking Fluid Levels
No Parts Required
Procedure
Before starting the engine for the first time, check the engine
oil and hydraulic fluid levels; refer to Checking the Engine-Oil
Level (page 24) and Checking the Hydraulic-Fluid Level (page
16) for more information.
3
Charging the Battery
No Parts Required
Procedure
Charge the battery; refer to Charging the Battery (page 29)
for more information.
11
Use
Advertisement
Table of Contents
