Table of Contents
Advertisement
Figure 13
6.
Tighten the wing nut on the clamp
Figure 14
1. Bolt
2. Washer
7.
Route the cable down the front of the ROPS
frame, ensuring that it cannot be trapped or
chafed when the ROPS is folded or raised.
8.
Connect the cable to the mating connector on
the main wiring loom with the yellow and black
wires.
g344044
(Figure
14).
g344045
3. Lock washer
4. Wing nut
•
On model 31654, the mating connector is
located near the horn.
•
On models 31657 and 31659, the mating
connector is located under the plastic
bulkhead at the bottom of the right ROPS
post.
9.
Insert a cable tie through each of the 2 holes
in the beacon bracket
the cable.
1. Holes (beacon bracket)
Installing the Beacon on a Machine
with a Cab
Note:
The wire harness is not required for installation
on a machine with a cab (wiring supplied in cab).
1.
Install the beacon stand to the beacon bracket
(Figure
16).
1. Beacon stand
2. Seal
3. Nut
2.
To fit the beacon cable, start by removing the
fitting in the top of the beacon stand and feed
5
(Figure
15), and secure
Figure 15
Figure 16
4. Ferrite
5. Beacon cable
g344048
g344082
Advertisement
Table of Contents
