Operation; Using The Beacon; Maintenance; Replacing The Fuse - Toro 02856 Installation Instructions Manual

Operation

Using the Beacon

To turn on the beacon, press the bottom of the switch.
To shut off the beacon, press the top of the switch.
Note:
The ignition switch must be in position 1 for
the beacon to work.

Maintenance

Replacing the Fuse

Replacing the Fuse on Model
31654
1. Remove the fuse-block cover
1. Fuse-block cover
2. Remove the 10 A fuse from the slot in the fuse
block located at the 3rd position from the right
(Figure 29).
(Figure 28).
Figure 28
1. 10 A fuse
3. Insert a 10 A fuse into the slot of the fuse block
located at the 3rd position from the right
29).
Important:
type and amperage as the one you are
replacing; otherwise, you could damage the
electrical system.
Note:
Ensure that the fuse is fully seated.
4. Install the fuse-block cover
Replacing the Fuse on Models
31657 and 31659
1. Remove the storage compartment; refer to
Removing the Storage Compartment (page
2. Remove the fuse-block cover
g188141
g037069
1. Fuse block
3. Remove the existing beacon light fuse and insert
a 10 A fuse in the same slot.
9
Figure 29
2. Fuse block socket (3rd
position from the right)
Always use a fuse of the same
(Figure
(Figure
Figure 30
2. Fuse-block cover
g188128
(Figure
28).
1).
30).
g328464