Panasonic WV-Q117E Instructions

FEATURES
Ceiling hanging bracket:
This bracket can be used to hang the camera
from a suspended ceiling or other location that is
not strong enough to hold a screw.
PRECAUTIONS
• Fasten the bracket to a ceiling strong enough
to support the camera weight (approx. 2.9 kg
{6.38 lbs}).
• Wipe the bracket regularly using a soft and
dry cloth, or a cloth moistened with a water
solution of an ordinary kitchen detergent.
• Do not use chemicals for cleaning the enclo-
sure as it may damage the surface.
• All the necessary steps required for installing
this product must be taken by a qualified ser-
vice person or system installer.
Ceiling Mount Bracket
Instructions
WV-Q117/WV-Q117E
Model No.
Before attempting to connect or install this product,
please read these instructions carefully and
save this manual for future use.
The model number is abbreviated in some descrip-
tions in this manual.
AF0205-5012 3TR003442FAA Printed in Japan
• Be sure to use the aniti-fall wire.
• Do not use this bracket except with suitable
cameras.
• Follow all applicable local and national elec-
trical, fire and safety codes when installing
the camera with this ceiling mount bracket.
The model numbers in this Operating Instruc-
tions are shown without suffix.
INSTALLATION
1 Decide where to install the camera and open
a φ60 mm {2-3/8"} hole in the ceiling.
2 Setting up the Mounting board.
For suspended ceilings
(1) Prepare a Mounting board long enough to
span the distance between the C-beams,
and cut a φ60 mm {2-3/8"} hole in it that
matches the hole in the ceiling.
(2) Use the template (provided) to cut four φ6
mm {1/4"} holes (in four positions) in the
mounting board.
For structurally strong ceilings
Prepare the mounting board by cutting a φ60
mm {2-3/8"} hole in it.
3 Attach the Ceiling Mount Ring (provided) to
the Mounting board Screws are not provided.
Align it with the position the camera will be
installed.
4 Installing the Mounting board.
For suspended ceilings
Align it with the hole in the ceiling and lay it
across the two C-beams.
For structurally strong ceilings
Align it with the hole in the ceiling and attach
it.
5 Remove the Mounting Screw (M3, provided),
pull up the Camera Mounting Base off the
camera, and turn the camera counterclock-
wise.
6 Remove the two Lock Lug Fixing Screws and
replace the Lock Lug with L-type.
Retighten the two Lock Lug Fixing Screws
(refer to the right figure).
Recommended tightening torque: 0.68 N · m
{0.51 lbf · ft}
Ceiling
C beam
60 mm in diameter
M beam
{2-3/8"}
Mounting board
Ceiling board
Mounting board
Ceiling board
7For suspended 7For structurally
ceilings strong ceilings
Ceiling Mount Ring Ceiling Mount Ring
(provided) (provided)
Wood screws
(not provided)
M4 Screws
(not provided)
Mounting
Screw
15°
Rotate
Remove the Camera
Mounting Base by
pulling up.
Lock Lug
Fixing Screws
Lock Lug
Lock Lug
Fixing Screws
L-type Base Lug (provided)