Panasonic EP-30004K Operating Instructions Manual page 22

Household massage lounger
Table of Contents

Advertisement

1. Body scanning will commence when the program is selected.
The body scanning will properly detect height ranges between approximately 4'7" and 6'8" (140 and 185 cm).
Sit as far back in the seat as
possible with your head on the
pillow.
NECK (Neck)
1
SHOULDER (Shoulder)
2
MIDDLE (Back)
3
LOWER (Lower back)
4
2. Approximately 30 seconds after the body scanning starts, the massage heads slowly lower to the shoulder
position, and a soft tapping action begins to determine your shoulder height.
Massage Head
Tapping
action
3. Confirm that the shoulder position has been correctly determined according to the position of the soft tapping.
When the shoulder position is incorrect, adjust the shoulder position while the soft tapping is in progress (for
approximately 15 seconds), and use the POSITION button to move the massage heads up or down.
4. The massage will start after body scanning is complete.
The legrest height will adjust automatically based on the body scanning results. The soles of the feet should be touching
the footrest wells. You may still adjust the length of the legrest with the lever on the right side of the seat (see next page).
You may also further adjust the height of the ottoman electronically (see page 34).
19
EP30004.indb
19
1
2
Adjust the pillow
3
height so that the
bottom edge of the
4
pillow is at ear level.
See page 37.
Too high
Correct position of the massage head
(The point where the tapping action should be felt.)
Too low
A single press of the button will raise or lower
the massage heads approximately 0.5" (1.2 cm).
The unit will automatically
recline to the correct
measuring position.
Correct Massage
Position
Raised
approx. 55˚
Keep your head on the pillow until the soft tapping begins.
Lifting your head from the pillow will result in incorrect
determination of the shoulder position.
Reclined
approx. 12˚
2007/06/22
13:49:13

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ep30004

Table of Contents