Table of Contents
Advertisement
Programmable to the
intelligent input terminal 1-8
FW
RV
LAC (LAD cancellation signal)
Input
terminal
PCLR (Position deviation Clear signal)
ORT (Orientation signal)
STAT(Pulse train input permission signal)
CM1
POK (Positioning completion signal)
Output
ZS
terminal
DSE (Speed deviation excessive signal)
H
O
L
intelligent output terminal 1-5
4.3 Terminal connection diagram
(Note 1) : Please refer to the instruction manual of the inverter main body about the wiring of the
logic board.
(Note 2) : Use a twisted and shielded wire for the signal cables, and cut the shielded covering as
shown in the diagram below. Make sure that the length of the signal cable is 20 meters
or less. If the length exceeds 20 meters, please use a VX application control device
RCD-E (remote control device) or CVD-E (insulation signal) to avoid malfunction
caused by EMC noise or voltage drop. Also, electric wire for the encoder uses twist
shield line of 0.75mm
the distance less than 20m. In case of more than 20m, please use the relay amplifier of
the 5V line driver specification output.
Chapter 4
Inverter main body control terminal
(Zero speed signal)
Programmable to the
Figure 4-2 Terminal wiring
2
or more (the example: Hitachi Cable, Ltd. KPEV-S), and make
Insulate
Connect to each common terminal
of the option board.
Get other manuals https://www.bkmanuals.com
WIRING AND CONNECTION
SJ-FB
(Feed-back board)
EP5
EG5
EAP
EAN
EBP
TM1
EBN
EZP
EZN
SAP
SAN
SBP
TM2
SBN
AP
AN
BP
BN
Unnecessary ground
connection
12
Encoder signal
M
EC
Motor with
the encoder
Pulse line position
command
Encoder
signal output
Advertisement
Table of Contents
