Prior To Use; Inserting The Batteries; Connecting The Earphones - Silvercrest SSRM 10 A1 Manual

SilverCrest SSRM 10 A1

Prior to use

Inserting the batteries

First, insert the supplied batteries (C). To do this, open the battery
compartment at the back of the device by sliding the battery
compartment cover (9) to the side in the direction of the
imprinted arrow and removing it. Insert the batteries (C) with the
correct polarity (pay attention to the + and - marks). The polarity
is illustrated on the batteries and in the battery compartment.
Then slide the battery compartment cover (9) back on the device
housing until it snaps into place.
If the volume decreases or if the device is not working, replace
the batteries (C) with new batteries of the same type. By flashing
"Low battery power" (18) on the display (1), the device indicates
when the battery capacity is exhausted. Please note that all data
(clock settings, alarm times and station presets) is lost when the
batteries are changed.

Connecting the earphones

Insert the jack plug of the supplied earphones (B) as far as
possible into the earphone jack (8) on the side of the device.
English - 13