Eco Operation Mode; Plasmacluster Mode; Full Power Mode; Other Functions - Bosch Climate Class 6000i Operation Manual

Examples for drying mode:
1°C higher
2°C lower
Table 7
If the outside temperature is very low, the heating capacity of the air
conditioning system may not be sufficient. We recommend connecting
additional heat sources.
Set fan speed
▶ Press the Fan button to set the desired fan speed.
1 2
[1] Auto
[2] Quiet
[3] Soft
[4] Low
[5] High
The fan speed cannot be adjusted in automatic mode or
dehumidification mode.
Switching the appliance off
▶ Press the Stop button.
The green operation lamp K turns off.
3.8

Eco operation mode

The air conditioner will operate with lower power consumption than
usual in this mode.
▶ During operation, press the Eco button to reduce power
consumption.
The remote control displays
active.
To cancel the operation mode:
▶ Press the Eco button again.
3.9

Plasmacluster mode

Plasmacluster ions released into the room are effective against airborne
contaminants, such as mold, viruses, and allergens.
▶ During operation, press button.
The remote control displays
The blue plasmacluster lamp on the unit lights up.
To cancel:
▶ Press button again.
The blue plasmacluster lamp on the unit turns off.
Climate Class 6000i/8000i – 6721831490 (2022/11)
3 4 5
0010035985-001
while the operation mode is
.
NOTICE
▶ Use of the plasmacluster mode will be memorized, and it will be
activated the next time you turn on the air conditioner.
▶ To perform the plasmacluster mode with fan only mode, press the
plasmacluster button while the unit is not operating. The operation
mode symbol at the top left on the remote control will disappear and
the fan speed can not be set to auto.
3.10

Full power mode

In this operation mode, the air conditioner works at the maximum power
to rapidly heat or cool the room.
▶ During operation, press the
The remote control displays
To cancel full power mode:
▶ Press the button again.
The unit returns to its original settings.
Full power mode will automatically cancel after one hour.
You can not set the temperature or fan speed during full power mode.
3.11

Other functions

3.11.1 Setting the swing function

NOTICE
If the louvres remain in the lowest position in cooling or drying mode for
an extended period, condensate may be discharged. Adjusting the
louvres by hand may cause faults.
▶ Only use the remote control to adjust the louvres.
Vertical Swing mode
▶ Press the button to set the desired airflow direction.
The adjustment possibility of the combustion air supply depends on the
operation mode selected:
• In cooling or drying mode, the combustion air supply can also be
directed to the ceiling.
• In heating mode on the other hand, the combustion air supply can be
selected for the underfloor
• Automatic mode does not allow any flow settings to the ceiling or
underfloor.
The setting AUTO has the following behaviour:
• Cooling mode: the airflow direction will be set obliquely downward,
and then shifted to horizontal or obliquely upward to direct cool air at
the ceiling.
• Heating mode: the airflow direction will be set obliquely upward
when the extract air temperature is low, then shifts to obliquely
downward when the extract air becomes hot.
• Dry mode: the airflow direction will be set obliquely upward.
Operation
button.
and the temperature disappears.
0010035536-001
49