Table of Contents
Advertisement
6. Remove the Integrator Block Ass'y by removing the 4 screws.
7. 1) Remove the three Integrator 1 Springs by removing the 3 screws.
2) Remove the Integrator 1 from the Integrator Holder Unit.
8. 1) Remove the two PS Springs by removing the 2 screws.
2) Remove the P/S Converter by releasing the tabs of PS Holder.
3) Remove the AL Mask.
4) Remove the Integrator 2 by releasing the tabs of PS Holder.
Note:
Clean the optical components if necessary. Refer to "Cleaning Methods" in Maintenance.
421
Boss
421
Integrator Block Ass'y
AL Mask
Flat side
PS Spring
408
View B
408
PS Spring
421
421
Integrator Holder Unit
Flat side
PS Holder
P/S Converter
PT-50LCZ70 / PT-56LCZ70 / PT-61LCZ70 / PT-50LCZ7 / PT-56LCZ7 / PT-61LCZ7
Reassembly Note 1:
Boss
The Integrator 1 Spring on this
side should face in the opposite
direction to the other two
Integrator1 Springs.
Integrator 1 Spring
(B1)
Flat side
(B2)
Integrator 2
(MP076LA1)
Fig. P4-2
47
View A
407
407
Integrator 1
Spring
407
Integrator 1 Spring
Integrator 1
(MP076LA1)
Advertisement
Table of Contents
