Toro Flex-Force Power System 88716 Operator's Manual page 7

Setup
1
Connecting the Attachment to the Power Head
No Parts Required
Procedure
1. Install the square shaft of the attachment into the square shaft of the power head (A of
2. Align the locking button on the lower shaft with the slotted hole on the upper shaft and slide the 2 shafts
together (B and C of
3. The locking button clicks into the slotted hole when the shafts are secured (C of
4. Using the screw-handle, tighten the screw on the shaft connector until it is secure (D of
Figure 3).
Figure 3
7
Figure 3).
Figure 3).
Figure 3).
g372305