Dell Optiflex 740 User Manual page 116

1 floppy drive 2 shoulder screws (4)
4. Attach the power and floppy-drive data cables to the floppy drive.
5. Connect the flopp- drive data cable to the DSKT connector on the system board (see
6. Install the drive panel to the front of the computer. The drive panel only fits one way (see
1 power cable 2 floppy-drive data
cable
7. Replace the computer cover (see
8. Enter system setup and use the Diskette Drive option to enable your new floppy drive (see
9. Verify that your computer works correctly by running the Dell Diagnostics (see
Media Card Reader
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the computer cover.
Removing the Media Card Reader
3 shoulder screw slots (2)
3 floppy-drive connector on system board
(DSKT)
Replacing the Computer Cover).
System Board Components
Drive-Panel Inserts).
Entering System Setup).
Dell Diagnostics).
for the connector location).