Table of Contents
Advertisement
NIC2-2 · Network ID Camera
4.4 Replacing the Main Board
Upper baffle
The CPU board is located inside the unit - rear side of the bottom plate.
If it is possible, it is recommended to save the current set-up in the unit before exchanging
the main board. To do so, please refer to Installation and Setup Manual chapter 3.8 'Remote
Control'.
• Remove the mains connection.
• Open the top of the camera and remove the upper baffle.
• To be able to exchange the CPU board it is necessary to remove the exposure unit.
Mark
Before doing that, make a mark of the exposure units position using a sharp tool as
shown in picture above. This will help you to reposition the unit after the CPU board is
replaced.
• Disconnect the two cables 'A' and 'B'.
Triacon AB Sweden
D
21
Publication no. 201102
CPU Board
A
B
D
C
September 2003
Advertisement
Table of Contents
