Table of Contents
Advertisement
NIC2-2 · Network ID Camera
4.5 Replacing the Keyboard
• Open the top of the camera.
B
C (x4)
•
Locate the small adapter board 'A' and disconnect the two MicroMatch connectors (red
ones). Note that the have a small polarizing pin on left side. Loosen the connector care-
fully to avoid damage on these pins.
• Disconnect the two flexi strip, coming from the keyboard, by gently pulling them out.
• Remove the keyboard support 'B' which is secured by four screws 'C'.
• Replace the keyboard.
Make sure the keyboard is correct positioned before tighten the screws 'C'. Best way to
do this is to verify that there is some space between the edges of the keyboard and the
top cover, ref. 'D'.
D (x4)
• Connect all cables and connectors.
• Close the top cover and secure it.
4.5.1 Keyboard test
A built in test program can be used for test of the keyboard.
• Holed down the P-key while power on the unit.
• Press Ctrl+T and select Keyboard test by pressing the M1-key, a graphic image of the
keyboard appear on the display. Now, pressing down one key will "fill" corresponding
position on the graphic image.
• Verify the keyboard by pressing each and one of the keys.
When done, switch the unit off and on again to start it up in normal mode.
Triacon AB Sweden
23
Publication no. 201102
A
September 2003
Advertisement
Table of Contents
