Table of Contents
Advertisement
14
Installing the WLAN Parts on the Mounting Plate
Fig. 4:
Pos. 1
Pos. 2
Pos. 3
Pos. 4
Pos. 5
Pos. 6
Pos. 7
Pos. 8
Pos. 9
Installing the WLAN Client
•
Insert the antennas
antenna sockets
•
Place the WLAN Client
(3/Fig. 4 / p. 14)
washers and nuts.
Installing the WLAN Power Supply
•
Place the WLAN power supply
place.
•
Place the two end pieces
and secure them in place.
ARCADIS
WLAN Client installed on the mounting plate
Mounting plate
WLAN Client
WLAN Client mounting points
Power supply
End pieces for the cap rail
24V power supply connection cable - WLAN Client
Power supply power cable - WLAN power switch
Threaded studs for ground wire connection
WLAN antennas, installed
(2/Fig. 3 / p. 13)
(3/Fig. 3 / p.
The illustration
(Fig. 4 / p. 14)
antennas following installation in the monitor carriages.
(2/Fig. 4 / p. 14)
on the mounting plate
If the power supply cannot be snapped in place, slightly pull out the latching lever
on the power supply
(8/Fig. 13 / p. 21)
rail. Let go of the latching lever. Check for correct seating of the power supply on
the cap rail.
(5/Fig. 4 / p. 14)
The power supply is secured against moving sideways on the cap rail.
DRAFT 22.04.2008
SP00-000.814.09.01.02
11.07
Installing the WLAN Expansion
and tighten the threads at both WLAN Client
13).
shows the approximate desired location of the
as shown on the threaded studs
(1/Fig. 4 / p. 14)
(4/Fig. 4 / p. 14)
on the existing cap rail and snap it in
and press the power supply onto the cap
to secure the power supply on the cap rail
Page 14 of 78
CS PS SP
and secure it in place with
Medical Solutions
0
Siemens
Advertisement
Table of Contents
