Husqvarna HG 125 VS Original Instructions Manual page 19

depressed, the trigger cannot be released.
plugging the tool in, check that the trigger
lock is "OFF". Accidental start-ups could
cause injury.
"Lock-ON" button. If the switch is locked
"ON" during the use, be ready for
emergency situations to switch it "OFF".
situations where kickback is likely, such as
when working into a corner. When the
wheel binds, the tool will kick-back in
opposite direction of wheel rotation and the
release of the trigger "Lock-ON" may be
difficult.
Slide Switch (Fig. 16)
TO TURN TOOL ON, press the back of the
switch and slide forward towards the gear
housing and into the ON position. TO
"LOCK-ON", when the switch is slid into the
"ON" position, roll the switch forward. TO
TURN TOOL "OFF", press the rear portion of
the switch. The switch is spring loaded and
will return to
automatically.
Operating Instructions
If the "Lock-ON" button
is continuously being
Never leave the trigger
locked "ON". Before
Be aware of the location
and setting of the switch
Do not use the switch
"Lock-ON" feature in
the "OFF" position
-19-