NEC UNIVERGE SV9100 System Maintenance Manual page 56

Issue 1.0
IP GW
IP ARP
IP ROUTE
IP DSP INFO
IP DSP INFO 1
Ping <ip address>
3 - 18
[RegId20][UserId:] not REGISTERED to SIP Server(1/30 8:50)
[RegId21][UserId:] not REGISTERED to SIP Server(1/30 8:50)
[RegId22][UserId:] not REGISTERED to SIP Server(1/30 8:50)
[RegId23][UserId:] not REGISTERED to SIP Server(1/30 8:50)
[RegId24][UserId:] not REGISTERED to SIP Server(1/30 8:50)
[RegId25][UserId:] not REGISTERED to SIP Server(1/30 8:50)
[RegId26][UserId:] not REGISTERED to SIP Server(1/30 8:50)
[RegId27][UserId:] not REGISTERED to SIP Server(1/30 8:50)
[RegId28][UserId:] not REGISTERED to SIP Server(1/30 8:50)
[RegId29][UserId:] not REGISTERED to SIP Server(1/30 8:50)
[RegId30][UserId:] not REGISTERED to SIP Server(1/30 8:50)
[RegId31][UserId:] not REGISTERED to SIP Server(1/30 8:50)
-----------------------------------
Enter
Displays the SV9100 Default
Gateway (PRG10-12-03)
Displays the SV9100 ARP
(Address Resolution
Protocol) cache. This is a
table of MAC address to IP
Address mappings.
Displays the SV9100 routing
table. Usually this will
consist of just a few entries,
as the default gateway is
used for any traffic destined
for a different IP subnet.
This shows how many DSP
channels are in use at a
particular moment in time.
This shows how many DSP
channels are in use at a
particular moment in time for
all device types.
The commonly used "ping"
utility has been implemented
on the GCD-CP10. This is a
very useful fault finding tool.
Function
[ Default Gateway ] : 192.168.1.254
See below
See below
See below.
See below.
VoIPU >ping 192.168.11.200
Pinging 192.168.11.200 with 32 bytes of
data:
Reply from 192.168.11.200:
Reply from 192.168.11.200:
Reply from 192.168.11.200:
Reply from 192.168.11.200:
Ping statics for 192.168.11.200:
Lost = 0 (0% loss):
UNIVERGE SV9100
DIM Output
Packets: Sent = 4, Received = 4,