Installation Of Swing Axle - Husqvarna Rider 13C Workshop Manual

Reparation instructions

Installation of swing axle

1
• Grease half of the axle (the half that has not
been turned down) and press it from the back
into the steering spindle (see diagram).
• Attach the washer and circlip on the swing
axle's inner holder.
• Fix the dust guard (with a thin lip behind)
approx. 2/3 of the way in on the axle and
lubricate the axle on both sides of the dust
guard.
2
Roll the rear frame forwards and press it in on the
swing axle.
36
– English
3 Rider 11 and Rider 11 C
• Attach a washer and circlip onto the swing axle
(1).
• Firmly secure the wires' holder plates (2), as
well as the gear and brake wires (3 and 4).
• Connect the belt onto the pulley and tightly
screw the tensioning wheel arm (5) onto the
rear frame.
• Attach the clutch wire (6) and the tensioning
wheel spring (7).
3 Rider 13 C, Rider 15 C and Rider 16
• Fit the washer and circlip on the swing axle.
• Fit the hydrostatic transmission wire and its
casing (2+4).
• Fit the cable on the neutral position contact (5).
• Fit the rear belt (8).
• Fit the brake wire on the arm under the tank
and the casing's holder on the rear frame (6).
• Fit the tensioning wheel spring (1).
• Fit the hydrostatic transmission's fan and the
circlip (7).
4 . Check that wires and controls are correctly
adjusted (see Inspection and adjusting of
respective wires). Finally, fit the cover on the
transmission/gearbox.
Check the setting of the neutral position
switch on machines with hydrostatic transmis-
sion, see "Electrical system\Microswitch
neutral position".