Table of Contents
Advertisement
Installing the heat sink
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE:
If either the system board or the fan and heat-sink assembly is replaced, use the thermal pad that is provided in the
kit to ensure that thermal conductivity is achieved.
CAUTION:
Incorrect alignment of the heat sink can damage the system board and processor.
The following image(s) indicate the location of the heat sink and provides a visual representation of the installation procedure.
Steps
1. Align and place the heat sink on the system board.
2. In sequential order (1>2>3>4), tighten the four captive screws (M2x6) that secure the heat sink to the system board.
3. Adhere the tape that secures the display-cable connector latch to the system board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Power button
Removing the power button
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
left
fan.
After working inside your
Before working inside your
computer.
computer.
Removing and installing components
43
Advertisement
Table of Contents
