Canceling The Registration Of An Adapter - Sharp HN-VA401SU Operation Manual

Canceling the Registration of an Adapter

Canceling the Registration of an Adapter
To cancel the network registration of an adapter, follow the steps below.
This should be done in the following situations:
♦
You attempted to register a separately purchased adapter, but
registration failed.
♦
You wish to change the registration of an adapter to a different network.
♦
You are going to discard or give an adapter to someone else, or have an
adapter serviced.
♦
If you suspect that someone is using an adapter to gain unauthorized
access to your network, cancel the registration of all adapters on your
network and then re-register the adapters.
Note: Perform the following steps with the adapter plugged into an
electrical outlet.
1
On the adapter whose registration you want to cancel, hold down the SET
button on the adapter until the POWER indicator turns off (about 10
seconds) and then release the button.
2
Wait until the POWER indicator turns back on. Registration cancellation is
now complete.
• Important: Do not remove the adapter from the outlet until the POWER
indicator turns on, as cancellation may not be complete. (It may take as
long as 30 seconds for cancellation to be completed.)
• To use the adapter again, you will need to register it as explained on page
11.
18
SET