Operating The Throttle; Operating The Ignition Switch; Operating The Pto-Engagement Lever - Toro Z Master 8000 Series Operator's Manual

Operating the Throttle

You can move the throttle control between the F
and S positions (Figure
LOW
Always use the middle position when turning on the
mower deck and blower with the PTO-engagement
lever.
Figure 17
Operating the Ignition
Switch
1. Turn the ignition key to the S
(Figure 18).
Note:
When the engine starts, release the key.
Important:
Do not engage the starter for
more than 5 seconds at a time. If the engine
fails to start, wait 15 seconds between
attempts. Failure to follow these instructions
can burn out the starter motor.
Note:
You may need multiple attempts to start
the engine when you start it the first time after
the fuel system has been without fuel completely.
Figure 18
2. Turn the ignition key to the S
off the engine.
AST
17).
G008946
g008946
position
TART
G008947
g008947
position to shut
TOP
Operating the
PTO-Engagement Lever
The PTO-engagement lever starts and stops the
mower blades and blower.
WARNING
An uncovered discharge opening allows
objects to be thrown at you and bystanders.
Also, contact with the blower blades could
occur. Thrown objects or blade contact can
cause serious injury or death.
Never operate the mower with the hopper or
hopper door raised, removed, or altered.
Engaging the PTO-Engagement
Lever
21
Figure 19
g032741