Setting For The Lan To Connect The Multiple Units - Sony Trimaster BVM-L170 Operation Manual

If 4 Asia Except Japan is selected:
Select Area
Asia Except Japan
NTSC Area B
PAL Area B
Customers who will use this monitor in the shaded
areas shown in the map below should select NTSC
Area.
Other customers should select PAL Area.
Then press the ENTER (Ent) button.
3
Confirm the settings.
Select Area
XXXXXXXXXX
Color Temp: xx
Setup Level: xx
Component Level: xx
xx
Color Gamut Emulation:
Cancel
Confirm
Cancel: Select to cancel the setting and return to the
Select Area screen.
Confirm: Select to save the setting and end selecting
the area.
See "Default value for each area" on page 26 on the
setting value.
After saving and reflecting the setting, you can change the
setting with the menu.
• Color Temp (color temperature) (page 53)
• Setup Level (NTSC Setup Level: page 56, Betacam
NTSC area
• Component Level (page 56)
• Color Gamut Emulation (page 55)
PAL area
Setting for the LAN to Connect the
Multiple Units
You can control the multiple monitors using the controller
connected via each LAN (10/100) connector. You can also
control a specific monitor or monitor group.
Set an IP address to the monitors and the controller and a
monitor ID number and group ID number to each monitor.
1
2
3
Setup Level: page 56)
Set the NETWORK switches of each monitor and the
controller to PEER TO PEER.
NETWORK
PEER TO
LAN
PEER
NETWORK
LAN
Set the different IP address to each monitor and the
controller.
Monitor: Set the IP address in the Network Setting
menu of the System Configuration menu (page 72).
Controller: Set the IP address in the Network Setting
menu of the Controller menu (page 83).
Set Monitor ID and Group ID in the Network menu of
the System Configuration menu (page 72).
PEER TO PEER
Settings
27