Table of Contents
Advertisement
◆ Connection Method
Use this product as following.
(1) Connect the Ethernet cable to one of the five Ethernet ports. (Order not specified)
(2) Confirm that the connector connected to each port is accurately mounted.
(3) Wire the power line "+" side to "PW +" on the power terminal block, and wire the power
line "-" side to "PW-".
Ground wire to "FG" and apply DC12 to 48V.
(4) If all the connected units are in the linked state, the Link/Activity LED to which the cable is
connected lights up and communication starts.
(Refer to Table 3.3 in "3. Specifications" for the lighting and blinking pattern.)
● Precautions for wiring and use
(1) Always connect the type of Ethernet cable specified in this Userʼs Manual.
(2) When connecting an Ethernet cable, the cable length and working temperature range may
be limited. Always refer to the specifications for the cable being used and connect it correctly.
(3) Securely connect the connector until a "click" is heard.
(4) Make sure that the cableʼs weight or tension is not directly applied on the connector.
The transmission loss could increase, and the wires could break.
(5) When connecting a repeater hub with a cascade connection, the number of connected levels
and cable length may be limited. (For more details, refer to the instruction manual for the
applicable repeater hub.)
●Installation method
・Installation on DIN rail
It is possible to install this product on DIN rail (35mm).
1）Hang the upper part of DIN rail attachment on DIN rail.
2）Push the lower part of this product until it sounds "click".
（Detaching method）
Remove the lower hook from the DIN rail while moving the main
body downward.
Please do not attach this product upside down.
- 5 -
Figure 5.1 Installation method
Advertisement
Table of Contents
