Husqvarna HG 125 B Original Instructions Manual page 20

6. Screw in side handle to secure stability
bracket between the tool housing and
handle.
7. Adjust guard to desired depth of cut.
TO REMOVE: Reverse procedure.
INSTALLING DRY DIAMOND WHEEL
(Fig. 11)
1. Place the backing flange on the spindle.
Turn flange until it locks with the base of
the spindle.
2. Place the dry diamond wheel onto the
spindle and align the arbor hole of the
grinding wheel with the shoulder of the
backing flange.
3. Thread on the quick-clamping nut. While
holding the spindle lock, tighten nut using
the fold-up bar.
TO REMOVE: Reverse procedure.
Inserting and Releasing
Battery Pack
This tool is equipped with Automatic
Restart Protection. This feature helps
prevent accidental startups after power has
been interrupted, e.g. the battery was
removed with the switch locked in the on
position. To resume operation, turn the side
switch to the off position, and back to on
position to restart the tool.
Make sure that the side switch (Fig. 13) is
in the off position before inserting or
removing battery pack. To insert the battery
pack slide it into the housing until the
battery pack locks into position.
Your tool is equipped with a secondary
locking latch to prevent the battery pack
from completely falling out of the handle,
should it become loose due to vibration.
Assembly
CLAMPING NUT
BACKING
FLANGE
QUICK-
CLAMPING
NUT
BACKING
FLANGE
SPINDLE
To remove the battery pack, press the
battery pack release button and slide the
battery pack forward.
Press the battery pack release button again
and slide the battery pack completely out of
tool housing (Fig. 12).
-20-
QUICK-
SPINDLE
FIG. 12
FIG. 11
DRY
DIAMOND
WHEEL
DRY
DIAMOND
WHEEL