Setup; Part Names And Functions; Led Indicator - Panasonic KX-HNB600C Setup Manual

Setup

Part names and functions

A
C D E
G
Speaker

LED indicator

DC jack
LINE jack
MWi-Fi SETUPN
Used when performing initial setup.
microSD card slot
Used when inserting a microSD card.
Remove the label when inserting.
M HANDSET/LOCATORN
Used when registering a handset. You
can also press this button to locate a
misplaced handset.
M CAMERAN
Used when registering a camera.
M OTHER DEVICEN
Used when registering other devices,
such as sensors and smart plugs.
For assistance, visit www.panasonic.ca/english/support
10
HNB600C_(en_en)_0113_ver.201.pdf
B
F
H I
10
LED indicator
You can use the LED indicator to confirm the
hub's status.
Indicator Status
Off No power, or LED
indicator is turned
off
Green, lit Normal operation,
connected to
wireless router
Green, blinking Registration mode
slowly
Green, blinking Hub is searching for
quickly wireless router
Alternating: Hub is starting up
Green, blinking (cannot be used
slowly
yet)
Yellow, blinking
slowly
Red, lit Alarm system is
armed
Red, blinking quickly Alarm system was
triggered
Yellow, lit Initial setup required
Yellow, blinking Initial setup in
slowly progress, mobile
device connected
Yellow, blinking Initial setup is
starting
*1 You can configure the hub so that its LED
indicator does not light during normal
operation. For more information, refer to
the User's Guide (page 16).
*2 It may take some time for the hub to finish
starting up.
*1
*1
*2
*1
2017/01/13 11:52:25