Panasonic KX-HNB600C Setup Manual page 13

4
Change your mobile device's Wi-Fi
setting temporarily so that it connects to
the hub directly.
R Open your mobile device's [Settings]
app, tap [Wi-Fi], select
"KX-HNB600_Panasonic", enter
"00000000" as the password, and then
tap [Join].
R If more than 1 item named
"KX-HNB600_Panasonic" is displayed,
wait approx. 10 minutes and perform
this procedure from the beginning.
5
Start the [Home Network] app again.
6
If necessary, enter the password required
to connect to your wireless router and
then tap [Next].
R The hub and your mobile device
connect to your wireless router.
R If prompted, follow the on-screen
instructions and connect your mobile
device to your wireless router, start the
app again, and then tap [Add This
Mobile Device].
R If you enter the wrong Wi-Fi password,
[Setup failed.] is displayed and the
hub's LED indicator lights.
Proceed as follows according to the
colour of the hub's LED indicator.
– If the LED indicator is lit in yellow,
repeat the initial setup procedure
from the beginning.
– If the LED indicator is blinking
quickly in green, you must reset the
hub's Wi-Fi settings. See "If the
hub's LED indicator blinks in green",
page 13.
7
When prompted, press MWi-Fi SETUPN
on the hub.
R Your mobile device will be registered
to the hub.
8
When prompted, follow the on-screen
instructions and set the password used to
log in to the hub while away from home
and then tap [OK].
9
When prompted, enter a name for the
hub and for your mobile device and then
tap [OK].
R The hub name setting is used by your
mobile device to identify the hub. This
is useful when you have multiple hubs.
For assistance, visit www.panasonic.ca/english/support
HNB600C_(en_en)_0113_ver.201.pdf
R The mobile device name setting is
10
When prompted, select whether you want
to customize device profiles, i.e., the
device name, location, and other settings
for your devices.
R If you choose not to customize the
R If you choose to customize the device
R The app's home screen is displayed
If the hub's LED indicator blinks in green
If you enter the wrong Wi-Fi password during
the initial setup procedure for iPhone or iPad,
[Setup failed.] is displayed and the hub's LED
indicator blinks quickly in green. In this case,
perform the following.
1. Press and hold the 3 registration buttons
on the side of the hub and MWi-Fi SETUPN
on the back of the hub at the same time (4
buttons total) until the hub's LED indicator
blinks slowly in green and yellow.
2. Wait for the hub's LED indicator to light in
yellow.
3. Repeat the initial setup procedure ("Initial
setup for iPhone, iPad", page 12 ).
Initial setup for Android devices
1
Start the [Home Network] app.
R If prompted, follow the on-screen
R If prompted to select the device to be
2
When prompted, tap [Set up the Hub].
13
used by the hub and other system
users to identify your mobile device.
This is useful when performing certain
operations, such as deregistering or
making intercom calls using a cordless
handset.
device profiles now, you can change
them later if desired. For details about
customizing device profiles, refer to the
User's Guide (page 16).
profiles now, change each setting as
desired. When finished, tap
repeatedly until the "completed"
message is displayed.
when initial setup is complete.
instructions and select the appropriate
region/country.
set up, tap [Hub].
2017/01/13
Setup
13
11:52:26