Table of Contents
Advertisement
Adjusting the Rear Grass Shield
Note:
When operating in turf conditions where there
is excessive debris or thatch, open the rear discharge
shield to help allow the debris to discharge from the
reel.
1.
Loosen the bolts on the pivot of the grass shield
(Figure
10).
Figure 10
1. Rear grass shield
2.
Rotate the grass shield to the desired setting,
and tighten the bolts
CAUTION
Do not open the rear shield so that it is
higher than level to ground.
Thrown debris could cause personal
injury.
Adjusting the Roller Scrapers
1.
Loosen the flange nuts that secure the roller
scrapers
(Figure
2. Pivot bolt
(Figure
10).
11).
1. Front roller scraper
2. Rear roller scraper
2.
Move the scraper rods in or out to attain 0.0 to
0.75 mm (0.0 to 0.03 inch) clearance between
the scraper and roller.
3.
Ensure that the scraper rod is parallel to the
g028403
roller and to the level surface.
4.
Tighten the flange nuts to lock the adjustment.
Adjusting the Transport Rollers
Important:
Before the verticutters are lowered to
the shop floor or removed from the traction unit,
lower the transport rollers
the blades from hard surface contact.
1.
Remove the cotter pin that secures the transport
roller bracket to the side plate pin.
2.
Position the transport roller as follows:
•
Lower the roller bracket before the verticutter
is lowered to the shop floor.
•
Raise the roller bracket after the verticutter is
raised to the operating position.
3.
Secure the transport roller bracket to the side
plate pin with the cotter pin.
4.
Repeat the procedure on the opposite end of
the verticutter.
10
Figure 11
3. Transport roller
4. Cotter pin
(Figure
11) to protect
g028404
Advertisement
Table of Contents
