Panasonic SD-YD250 Manual page 4

Cause
1. Too much water
User-side
2. Too little flour
problems
3. Too much tightening of the connector at the back of the bread
pan
1. Insufficient gas let-out resulting from defective kneading blade
Bread maker
rotation. / Defect caused by the bread pan's mounting shaft unit
problems
defects
1.1.6. Symptom : Wet bread bottom or dented bread's side faces
Cause
1. Leaving of the bread in the bread pan
User-side
problems
1.1.7. Symptom : Kneading blade does not turn. Abnormal sound while kneading
Cause
1. Bearing defects in the bread pan
Bread maker
2. Insufficient kneading due to a belt
problems
3. Motor defects (Normal resistance: See
1.1.8. Symptom:Dry yeast does not drop from Yeast dispenser.
Cause
1. Static electricity could cause a small amount of dry yeast to be
Effect caused
left in the dispenser.
by static
electricity
Bread maker Check the operation of the solenoid and
problems yeast dispensing chute in
.
1. The solenoid operates correctly, butthe chute closes and
opens irregularly.
2. The motor runs, but the solenoid does not run.
3. A replaced solenoid does not run.
1.2. CHECK POINT
CHECK POINT)
Motor operation test
4
Remedy
1. Reduce water.
2. Observe the amount mentioned in the cookery
3. Do not tighten the connector too much.
1. Replace the mounting shaft unit.
Remedy
1. Take out the bread soon after baking is completed.
Remedy
1. Replace the mounting shaft unit.
2. Replace the belt.
3. Replace the motor
Remedy
Wipe the inner walls of the dispenser
with a wet cloth. After the inside
dispenser dries, put the yeast in
dispenser and see if it still sticks
inner walls of the dispenser. Ifit
doesn't, static electricity has been
removed. You can use the bread
normally.
1. Confirm the operation of the yeast dispensing
or lever and repair or replace the broken part
necessary.
2. Replace the solenoid.
3. Replace the PC Board Assembly.