Advertisement
15. Install the sunshade to the roof-support bracket using
2 clips, 2 sealing washers, and 2 hex-flange bolts (1/4 x
1 inch) as shown in
Figure 14
1. Sunshade
2. Clip
16. Install the sunshade to the front plates using 2 clips, 2
sealing washers, and 2 hex-flange bolts (1/4 x 1 inch)
as shown in
Figure
Important: Apply thread-locking compound to
the hex-flange bolts (1/4 x 1 inch) before installing.
Figure 15
1. Hex-flange bolt (1/4 x 1
inch)
2. Sealing washer
3. Sunshade
Figure
14.
3. Hex-flange bolt (1/4 x 1
inch)
4. Sealing washer
15.
4. Clip
5. Front plate
17. Install the sunshade to the rear crosslink using 2
hex-flange bolts (1/4 x 1 inch), 2 sealing washers,
2 friction washers, 4 plastic washers, and 2 flange
bushings
(Figure
Important: Apply thread-locking compound to
the hex-flange bolts (1/4 x 1 inch) before installing.
Important: Ensure that the plastic washers are
installed onto the top and bottom of the sunshade,
as this prevents damaging the sunshade.
1. Hex-flange bolt (1/4 x 1
inch)
2. Sealing washer
3. Friction washer
6
16).
Figure 16
4. Plastic washer
5. Flange bushing
6. Rear crosslink
Advertisement
