Kenwood CK 405 Operating Instructions Manual page 22

INSIDE OF OVEN
The oven should always be cleaned after
use when it has cooled down .
The bottom of the oven, side runner frames,
tray and rack can be removed and washed .
The cavity should be cleaned using a mild
detergent solution and warm water .
Suitable proprietary chemical cleaners
may be used after first consulting with
the manufacturers recommendations and
testing a small sample of the oven cavity .
Abrasive cleaning agents or scouring pads/
cloths should not be used on the cavity
surface .
NOTE: The manufacturers of this appliance
will accept no responsibility for damage
caused by chemical or abrasive cleaning .
Let the oven cool down and pay special
attention no to touch the hot heating
elements inside the oven cavity.
ASSEMBLY AND DISMANTLING OF
THE SIDE RUNNER FRAMES
• Fit the side runner frames into the
holes on the side walls inside the oven
(fig. 8.6).
• Slide into the guides, the shelf and the
tray (fig. 8.7).

The rack must be fitted so that the
safety notch, which stops it sliding out,
faces the inside of the oven; the guard
rail shall be at the back .
• To dismantle, operate in reverse order .
22
Guard rail
Fig. 8.6
Stop notch
Fig. 8.7